Home > Applications guide > Conformal coatings
Major Properties of Water Repellent FluoroPel Conformal Coatings Include:
- Designed for moisture, corrosion and tin whisker protection of circuit boards
- Dries to a thin, lightweight, transparent film with excellent hydrophobic and oleophobic properties
- Dries at room temperature in minutes and is reworkable
- Polymer and solvents are low in toxicity, non-ozone depleting and RoHS compliant
- Versions with a dye that fluoresces under UV light is available
- Provides better moisture repellency for the same film thickness compared to urethane, silicone and acrylic conformal coatings
- Contains no silicone and causes no contact failure of electric contact points
- Can be applied by dipping, brushing, damming, spraying, capillary or syringe dispensing

Our staff is available to assist you with selecting the best FluoroPel product for your application. Please email (emailbox@cytonix.com) or call (301.470.6267) for assistance.

PRODUCT DOCUMENTS:
Technical data table
Sort By:
Page of 1
FluoroPel 0.2
Our Price: $49.00
FluoroPel 2.0
Our Price: $99.00
FluoroPel 0.2 is a fluoroacrylic copolymer solution at a concentration of 0.2% in a 80°C boiling point fluorosolvent. This conformal coating solution is also available in a 60, 130 and 200°C boiling point solvents. Formulations with UV-tracers are also available. In the 60 and 80°C boiling point solvents, thin films (less than 0.1 microns) dry in a few minutes at room temperature to a surface energy of about 10 dynes/cm, water contact angle over 110° and mineral oil contact angle over 70° . Warming to 50°C for 10 minutes can reduce cure time. Please contact Cytonix for help with product selection or with any questions.
FluoroPel 2.0 is a fluoroacrylic copolymer solution at a concentration of 2% in a fluorosolvent. This conformal coating solution is available in a 60, 80, 130 and 200°C boiling point solvents. Formulations with UV-tracers are also available. In the 60 and 80°C boiling point solvents, thin films (0.2 microns) dry in a few minutes at room temperature to a surface energy of about 10 dynes/cm, water contact angle over 110° and mineral oil contact angle over 70°. Warming to 50°C for 10 minutes can reduce cure time. Please contact Cytonix for help with product selection or with any questions.